Innokin Sceptre Instructions
How to operate the Innokin Sceptre
To power the device on/off, press the fire button 3 times in quick succession.
The Innokin Sceptre features dual activation meaning you can activate it by simply inhaling on the mouth piece or holding the fire button. The device features a boost mode, creating more heat and flavour. To activate, press and hold the fire button, the LED light will cycle to purple to indicate boost mode is active.
The wattage can be adjusted by first powering the device off. You can then hold the fire button to cycle between the wattage outputs:
MTL (1.2 ohm): Green (9W), Pink (10W)
DTL (0.5 ohm): Green (18W), Pink (20W)
To adjust the airflow on the Sceptre, first remove the pod from the device. The airflow slider can then adjusted to provide a MTL or restricted DLT vape.
How to charge the Innokin Sceptre
The device features a large capacity 1400mAh battery, easily providing a days worth of vaping. The indicator light will show how much charge the device has; Green (over 50% charge), Blue (49%-10% charge) and Red (under 10% charge). To charge the Innokin Sceptre, simply insert the USB charging cable into the device. The indicator light will show how much charge the device has; Green (over 90% charge) and Red (89% – 0% charge). The indicator light will turn off when fully charged.
How to fill the Innokin Sceptre Pod
To fill the device, remove the pod from the battery. Open the silicone tab on the side of the pod and then fill the tank with your favourite OK Vape E-Liquid. Once the pod is full, close the tab and insert the pod back into the battery.
How to replace the coil In your Innokin Sceptre
You’ll need to change you coil when you notice a deterioration in flavour or experience a burnt taste. Depending on how much you vape, you’ll probably need to change your coil every 1-3 weeks.
To replace the coil, first remove the pod from the battery. Twist the base of the pod open and remove it with the coil attached. The coil can the be unscrewed and replaced with a new one before the base is twisted back onto the pod. Once you’ve replaced the coil, fill your pod up with e-liquid and leave it to stand for at least five minutes before vaping to prime the coil.
Battery Safety Information
Please read the included instructions fully and follow battery safety advice. Never leave charging batteries unattended and take care not to overcharge the battery. If you are charging this kit from a mains adapter, ensure that maximum power output is 1 amp. You can purchase an OK Vape branded, safety assured 1 amp mains charging adapter here.
Power off the device when not in use.
