Aspire Flexus Q Equipment | 2 Free E Liquids | Free Supply

48 0
Aspire Flexus Q Rapid Charge Technology

Aspire Flexus Q Instructions

How to use the Aspire Flexus Q

To power the device on/off, press the fire button 5 times in quick succession, the indicator light will flash blue 3 times. The Aspire Flexus Q features dual activation meaning you can activate it by simply inhaling on the mouth piece or holding the fire button.

To adjust the air intake, simply slide the airflow control slider on the side of the device. The device also features 3 level power adjustment. To cycle between the 3 different power levels, press the fire button three times in quick succession, the indicator light will display which level the device is set to; Red (Low, Easy Mode), Blue (Mid, Medium Mode) and Green (High, Hard Mode).

How to charge the Aspire Flexus Q

The device features Aspires Q Quick fast charging technology. With it’s 3A rapid charging, the Flexus Q can reach up to 80% charge in just 10 minutes. The indicator light will show how much charge the device has; Green (over 60% charge), Blue (59%-30% charge) and Red (under 30% charge). Plug the USB C cable into the bottom of the device to charge.

How to fill the Aspire Flexus Q Pod

To fill the device, remove the pod from the battery and open the silicone stopper on the side of the pod. You can then fill the tank with your favourite OK Vape E-Liquid. Once the pod is full, the silicone stopper can be closed and the pod inserted back into the battery.

Filling the Aspire Flexus Q Pod

How to replace the coil In your Aspire Flexus Q

You’ll need to change you coil when you notice a deterioration in flavour or experience a burnt taste. Depending on how much you vape, you’ll probably need to change your coil every 1-3 weeks.

To replace the coil, simply remove the pod from the battery and remove the coil from the pod. A new coil can then be inserted into pod. Please ensure the pod is empty before changing the coil. Once you’ve replaced the coil, fill your pod up with e-liquid and leave it to stand for at least five minutes to prime the coil.

Battery Safety Information

Please read the included instructions fully and follow battery safety advice. Never leave charging batteries unattended and take care not to overcharge the battery. If you are charging this kit from a mains adapter, ensure that maximum power output is 1 amp. You can purchase an OK Vape branded, safety assured 1 amp mains charging adapter here.

Power off the device when not in use.

Leave a Reply